96347003 Rear Bumper for Daewoo Nubira ’00 / Nubira / Lacetti ’03 Optra

Rear Bumper for Daewoo Nubira ’00 / Nubira / Lacetti ’03 Optra: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Purchase Preparation

This rear bumper is associated with Daewoo Nubira ’00 / Nubira / Lacetti ’03 Optra. The references 96347003 support identification but do not replace a physical comparison. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Repair Planning Notes

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

The procurement contact should capture overall corner curvature, review bracket and bolt-hole spacing, and cross-check upper edge alignment below the lamps before the packing plan is prepared. This route applies to the rear bumper shown for Daewoo Nubira ’00 / Nubira / Lacetti ’03 Optra.

If images accompany the enquiry, include an adjacent-panel image, a fastener detail, and an underside image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with adjacent-panel image to capture overall corner curvature. A second image should show lamp or grille openings from fastener detail. Before the packing plan is prepared, review upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Daewoo Nubira ’00 / Nubira / Lacetti ’03 Optra vehicle record.

The procurement contact should mark lamp or grille openings from a lower-retainer view, then capture side-retainer engagement before the vehicle is dismantled. A vehicle inspector should inspect side-retainer engagement from an original-label photograph, then compare bracket and bolt-hole spacing before the replacement is test-positioned. A vehicle inspector should evaluate bracket and bolt-hole spacing from a connector close-up, then document lamp or grille openings before the purchase order is issued. The parts coordinator should mark bracket and bolt-hole spacing from a fastener detail, then mark lamp or grille openings before the delivery plan is confirmed.

Identification Summary

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 170 × 40 × 58CM / 5PCS; reconfirm current packing when freight is quoted.

Technical Comparison Notes

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Product Questions and Answers

Which vehicle record belongs with this product?

This rear bumper appears under Daewoo Nubira ’00 / Nubira / Lacetti ’03 Optra. Review the exact vehicle version rather than relying on the model name by itself.

How is the pictured version best verified?

Check overall corner curvature, confirm lamp or grille openings, and retain the removed part until the replacement has been compared side by side.

What information is needed for a quotation?

Send the order volume and destination together with VIN or chassis information where available. State the required side or installation position where that detail applies.