86615-2B000 / 86616-2B000 Rear Bumper Bracket for Hyundai Santa Fe ’09

Rear Bumper Bracket for Hyundai Santa Fe ’09: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Application Review

This rear bumper bracket is associated with Hyundai Santa Fe ’09. The numbers 86615-2B000 / 86616-2B000 are most useful when supported by VIN or chassis data and clear photographs. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Purchase Preparation

• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement

The procurement contact should confirm upper edge alignment below the lamps, document overall corner curvature, and compare side-retainer engagement before the carton is allocated. This route applies to the rear bumper bracket shown for Hyundai Santa Fe ’09.

If images accompany the enquiry, include an underside image, a chassis-plate image, and a fixing-point close-up. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with underside image to confirm upper edge alignment below the lamps. A second image should show bracket and bolt-hole spacing from chassis-plate image. Before the carton is allocated, document side-retainer engagement and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’09 vehicle record.

The service adviser should evaluate lamp or grille openings from a chassis-plate image, then photograph lamp or grille openings before the stock request is released. The service adviser should confirm side-retainer engagement from a fastener detail, then compare bracket and bolt-hole spacing before the stock request is released. The receiving technician should note lamp or grille openings from a fastener detail, then record bracket and bolt-hole spacing before the fitment decision is signed off. The parts coordinator should capture lamp or grille openings from a side-profile photograph, then align side-retainer engagement before the installation begins.

Replacement Selection Guide

Do not enlarge holes, bend brackets or force electrical plugs to compensate for a mismatch. No packing entry is published here; request current carton and quantity information with the quotation.

Identification Summary

A complete sourcing request names the quantity, delivery market and the comparison information used. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

How should the model application be interpreted?

The listing covers Hyundai Santa Fe ’09. Because configurations may vary, check the actual installation area before approving the rear bumper bracket.

How is the pictured version best verified?

Use the old component to check upper edge alignment below the lamps and bracket and bolt-hole spacing. Also state the installation side or position in the enquiry.

What should a distributor send for a quotation?

A complete sourcing request names the quantity, delivery market and the comparison information used. The supplier can then review the product version, carton requirements and delivery options.