86612-4H000 / 86613-4H000 Rear Bumper Iron Trim for Hyundai Starex ’05 / Starex ’08

Rear Bumper Iron Trim for Hyundai Starex ’05 / Starex ’08: For repair planning, compare the pictured item with the original part before confirming an order. The component belongs to the bumper inspection group.

Product Specifications

Identification Summary

This rear bumper iron trim is associated with Hyundai Starex ’05 / Starex ’08. An OEM match to 86612-4H000 / 86613-4H000 is one layer of evidence; hole spacing and surrounding parts provide another. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Fitment Evidence

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

The service adviser should compare overall corner curvature, measure bracket and bolt-hole spacing, and trace upper edge alignment below the lamps before the stock request is released. This route applies to the rear bumper iron trim shown for Hyundai Starex ’05 / Starex ’08.

If images accompany the enquiry, include an adjacent-panel image, a fixing-point close-up, and a full component outline. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The service adviser can begin with adjacent-panel image to compare overall corner curvature. A second image should show lamp or grille openings from fixing-point close-up. Before the stock request is released, measure upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai Starex ’05 / Starex ’08 vehicle record.

The installation team should inspect overall corner curvature from an underside image, then inspect overall corner curvature before the packing plan is prepared. The maintenance supervisor should capture overall corner curvature from an underside image, then capture overall corner curvature before the shipment is booked. The procurement contact should capture overall corner curvature from a connector close-up, then photograph side-retainer engagement before the quotation is approved. The service adviser should capture overall corner curvature from a fixing-point close-up, then photograph upper edge alignment below the lamps before the quotation is approved.

Installation Planning

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 66 × 50 × 45CM / 20PCS; reconfirm current packing when freight is quoted.

Procurement Checklist

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What vehicle information should be checked first?

The associated model designation is Hyundai Starex ’05 / Starex ’08. Confirm the body or electrical configuration relevant to this rear bumper iron trim.

What evidence is useful for a fitment review?

Check overall corner curvature, confirm lamp or grille openings, and retain the removed part until the replacement has been compared side by side.

What should be included in a B2B enquiry?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. This information helps separate technical confirmation from the later shipping calculation.