86611-0X220 Rear Bumper for Hyundai I10 ’11 / I10 ‘2014

Rear Bumper for Hyundai I10 ’11 / I10 ‘2014: This page brings the main vehicle, component and comparison details into one sourcing reference. The component belongs to the bumper inspection group.

Product Specifications

Workshop Comparison

This rear bumper is associated with Hyundai I10 ’11 / I10 ‘2014. Treat 86611-0X220 as an identification route, then validate the component at the actual mounting area. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Component Matching Record

• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement

A workshop estimator should review upper edge alignment below the lamps, inspect overall corner curvature, and cross-check side-retainer engagement before the stock request is released. This route applies to the rear bumper shown for Hyundai I10 ’11 / I10 ‘2014.

If images accompany the enquiry, include a removed-part overview, an underside image, and a full component outline. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A workshop estimator can begin with removed-part overview to review upper edge alignment below the lamps. A second image should show bracket and bolt-hole spacing from underside image. Before the stock request is released, inspect side-retainer engagement and note any difference from the removed component. Keep these observations with the Hyundai I10 ’11 / I10 ‘2014 vehicle record.

The installation team should document overall corner curvature from a fastener detail, then mark bracket and bolt-hole spacing before the shipment is booked. The procurement contact should cross-check lamp or grille openings from a rear mounting view, then cross-check upper edge alignment below the lamps before the delivery plan is confirmed. The repair planner should photograph side-retainer engagement from a removed-part overview, then confirm lamp or grille openings before the repair schedule is finalized. The installation team should document lamp or grille openings from a fixing-point close-up, then align lamp or grille openings before the stock request is released.

Buyer Verification Notes

Protect painted and finished surfaces during handling, and verify panel gaps before tightening fasteners. Recorded packing is 170 × 32 × 50CM / 5PCS; reconfirm current packing when freight is quoted.

Identification Summary

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What is the listed vehicle application?

The stated vehicle is Hyundai I10 ’11 / I10 ‘2014. Treat that model label as one part of the fitment check, together with photographs and chassis details.

How should fitment be checked before ordering?

Fitment evidence should show upper edge alignment below the lamps, bracket and bolt-hole spacing and the position where the component will be installed.

What should a distributor send for a quotation?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. This information helps separate technical confirmation from the later shipping calculation.