86530-0X100 Front Bumper Support for Hyundai I10 ’11 / I10 ‘2014

Front Bumper Support for Hyundai I10 ’11 / I10 ‘2014: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Repair Planning Notes

This front bumper support is associated with Hyundai I10 ’11 / I10 ‘2014. If 86530-0X100 appears on the original label or casting, continue by confirming holes, clips and clearance. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Configuration Check

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

The stock controller should capture overall corner curvature, verify bracket and bolt-hole spacing, and align upper edge alignment below the lamps before the repair schedule is finalized. This route applies to the front bumper support shown for Hyundai I10 ’11 / I10 ‘2014.

If images accompany the enquiry, include a removed-part overview, a connector close-up, and a rear mounting view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The stock controller can begin with removed-part overview to capture overall corner curvature. A second image should show lamp or grille openings from connector close-up. Before the repair schedule is finalized, verify upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai I10 ’11 / I10 ‘2014 vehicle record.

The receiving technician should trace lamp or grille openings from a chassis-plate image, then inspect side-retainer engagement before the packing plan is prepared. The stock controller should capture bracket and bolt-hole spacing from a corner-profile view, then inspect overall corner curvature before the shipment is booked. The receiving technician should confirm side-retainer engagement from a corner-profile view, then confirm lamp or grille openings before the purchase order is issued. The stock controller should review bracket and bolt-hole spacing from a fixing-point close-up, then document upper edge alignment below the lamps before the replacement is test-positioned.

Purchase Preparation

A qualified installer should resolve alignment or wiring differences before the vehicle returns to service. Recorded packing is 105 × 4 × 20CM / 1PCS; reconfirm current packing when freight is quoted.

Installation Planning

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Common Workshop Questions

What model is associated with this replacement part?

This page associates the front bumper support with Hyundai I10 ’11 / I10 ‘2014. The vehicle record and original component should agree with the pictured version.

How should fitment be checked before ordering?

Ask the workshop to inspect overall corner curvature together with lamp or grille openings. VIN or chassis information can clarify market-specific differences.

How should a wholesale request be submitted?

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Packing and freight can be discussed after the component version has been identified.