86523-A0000 / 86524-A0000 Fog Light Cover for Hyundai I30 ’12 / Ix25 / Creta

Fog Light Cover for Hyundai I30 ’12 / Ix25 / Creta: Parts selection should begin with the removed component and the exact vehicle record. The component belongs to the lighting inspection group.

This bezel version should be reviewed around the fog-light aperture rather than by colour alone. Compare the taper toward the centre grille, the depth of the lamp recess, the bumper-side edge return and the sequence of retaining clips. A straight-on bumper photograph plus a rear view of the removed cover gives the purchasing team a clearer configuration record.

Product Specifications

Ordering Information

This fog light cover is associated with Hyundai I30 ’12 / Ix25 / Creta. For purchasing documents, quote 86523-A0000 / 86524-A0000 exactly and add the destination market and vehicle information. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Procurement Checklist

• Left or right installation position
• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing

A vehicle inspector should document left or right installation position, document clearance beside bumper and grille, and record mounting tabs around the housing before the vehicle is dismantled. This route applies to the fog light cover shown for Hyundai I30 ’12 / Ix25 / Creta.

If images accompany the enquiry, include an adjacent-panel image, an original-label photograph, and an original-label photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A vehicle inspector can begin with adjacent-panel image to document left or right installation position. A second image should show lens profile and outer edge from original-label photograph. Before the vehicle is dismantled, document mounting tabs around the housing and note any difference from the removed component. Keep these observations with the Hyundai I30 ’12 / Ix25 / Creta vehicle record.

A workshop estimator should verify mounting tabs around the housing from an installation-opening picture, then document electrical plug and pin layout before the delivery plan is confirmed. The repair planner should trace clearance beside bumper and grille from a chassis-plate image, then measure clearance beside bumper and grille before the purchase order is issued. The stock controller should confirm lens profile and outer edge from a straight-on view, then measure lens profile and outer edge before the fitment decision is signed off. The maintenance supervisor should photograph lens profile and outer edge from a corner-profile view, then mark clearance beside bumper and grille before the replacement is test-positioned.

Vehicle-Side Evidence

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. No packing entry is published here; request current carton and quantity information with the quotation.

Technical Comparison Notes

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

What is the listed vehicle application?

The listing covers Hyundai I30 ’12 / Ix25 / Creta. Because configurations may vary, check the actual installation area before approving the fog light cover.

How should fitment be checked before ordering?

Check left or right installation position, confirm lens profile and outer edge, and retain the removed part until the replacement has been compared side by side.

What information is needed for a quotation?

Send the order volume and destination together with VIN or chassis information where available. The supplier can then review the product version, carton requirements and delivery options.