86520-K6010 Front Bumper Support (Bubble) for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d

Front Bumper Support (Bubble) for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d: Use the model label as a starting point, then verify the actual mounting layout on the vehicle. The component belongs to the bumper inspection group.

Product Specifications

Physical Fitment Points

This front bumper support (bubble) is associated with Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d. Use 86520-K6010 as the written lookup reference while also checking geometry and installation position. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Installation Planning

• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement

The importing distributor should note upper edge alignment below the lamps, photograph overall corner curvature, and trace side-retainer engagement before the commercial request is submitted. This route applies to the front bumper support (bubble) shown for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d.

If images accompany the enquiry, include an installation-opening picture, a removed-part overview, and an underside image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The importing distributor can begin with installation-opening picture to note upper edge alignment below the lamps. A second image should show bracket and bolt-hole spacing from removed-part overview. Before the commercial request is submitted, photograph side-retainer engagement and note any difference from the removed component. Keep these observations with the Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d vehicle record.

The receiving technician should confirm side-retainer engagement from a lower-retainer view, then note overall corner curvature before the carton is allocated. A collision-repair specialist should record upper edge alignment below the lamps from a corner-profile view, then review side-retainer engagement before the packing plan is prepared. A collision-repair specialist should photograph lamp or grille openings from a vehicle-side photograph, then note overall corner curvature before the vehicle is dismantled. A vehicle inspector should record lamp or grille openings from a rear mounting view, then assess overall corner curvature before the quotation is approved.

Workshop Comparison

Trial-position the component with nearby trim loosened only as required by workshop procedure. No packing entry is published here; request current carton and quantity information with the quotation.

Technical Comparison Notes

A complete sourcing request names the quantity, delivery market and the comparison information used. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

Which vehicle record belongs with this product?

This front bumper support (bubble) is listed for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d. Use that designation as a starting point and verify the vehicle configuration before ordering.

What should be compared with the removed component?

Use the old component to check upper edge alignment below the lamps and bracket and bolt-hole spacing. Also state the installation side or position in the enquiry.

How can a trade buyer request pricing?

A complete sourcing request names the quantity, delivery market and the comparison information used. Keep each requested product on a separate line when several parts share one shipment.