92401-K6000 / 92402-K6000 Tail Light Assembly for Hyundai I10 ‘2017 4d / Grand I10 ’21 / Nios 5d

Tail Light Assembly for Hyundai I10 ‘2017 4d / Grand I10 ’21 / Nios 5d: Match the item to the vehicle configuration before quantity and shipping terms are confirmed. The component belongs to the lighting inspection group.

Product Specifications

Configuration Check

This tail light assembly is associated with Hyundai I10 ‘2017 4d / Grand I10 ’21 / Nios 5d. Use 92401-K6000 / 92402-K6000 as the written lookup reference while also checking geometry and installation position. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Reference Check

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The installation team should cross-check clearance beside bumper and grille, measure lens profile and outer edge, and capture left or right installation position before the installation begins. This route applies to the tail light assembly shown for Hyundai I10 ‘2017 4d / Grand I10 ’21 / Nios 5d.

If images accompany the enquiry, include an original-label photograph, a connector close-up, and an original-label photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The installation team can begin with original-label photograph to cross-check clearance beside bumper and grille. A second image should show electrical plug and pin layout from connector close-up. Before the installation begins, measure left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai I10 ‘2017 4d / Grand I10 ’21 / Nios 5d vehicle record.

A vehicle inspector should photograph lens profile and outer edge from a chassis-plate image, then record left or right installation position before the fitment decision is signed off. The stock controller should review left or right installation position from a corner-profile view, then trace mounting tabs around the housing before the stock request is released. The receiving technician should align mounting tabs around the housing from a rear mounting view, then document electrical plug and pin layout before the installation begins. The importing distributor should note electrical plug and pin layout from a lower-retainer view, then inspect mounting tabs around the housing before the vehicle is dismantled.

Inspection Route

Keep protective wrapping in place where possible until the item has passed the initial comparison. No packing entry is published here; request current carton and quantity information with the quotation.

Vehicle Confirmation

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

What vehicle information should be checked first?

The recorded application is Hyundai I10 ‘2017 4d / Grand I10 ’21 / Nios 5d. Confirm trim, market specification and the removed tail light assembly before purchase.

How should fitment be checked before ordering?

Review clearance beside bumper and grille first, then inspect electrical plug and pin layout on the vehicle. Clear photographs help the supplier assess the required version.

What should a distributor send for a quotation?

Include packaging questions, requested quantity and the receiving country in the initial enquiry. This information helps separate technical confirmation from the later shipping calculation.