64101-0X010 Panel for Hyundai I10 ’07 / I10 ’11

Panel for Hyundai I10 ’07 / I10 ’11: This page brings the main vehicle, component and comparison details into one sourcing reference. The component belongs to the body inspection group.

Product Specifications

Workshop Comparison

This panel is associated with Hyundai I10 ’07 / I10 ’11. If 64101-0X010 appears on the original label or casting, continue by confirming holes, clips and clearance. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Installation Planning

• Bolt and clip locations
• Wheel-arch or lamp clearance
• Opening and hole pattern
• Left or right orientation
• Panel contour

The procurement contact should verify bolt and clip locations, verify wheel-arch or lamp clearance, and verify panel contour before the shipment is booked. This route applies to the panel shown for Hyundai I10 ’07 / I10 ’11.

If images accompany the enquiry, include a removed-part overview, a connector close-up, and a chassis-plate image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with removed-part overview to verify bolt and clip locations. A second image should show opening and hole pattern from connector close-up. Before the shipment is booked, verify panel contour and note any difference from the removed component. Keep these observations with the Hyundai I10 ’07 / I10 ’11 vehicle record.

A workshop estimator should capture bolt and clip locations from an underside image, then assess left or right orientation before the quotation is approved. The stock controller should mark panel contour from a corner-profile view, then confirm wheel-arch or lamp clearance before the vehicle is dismantled. The maintenance supervisor should cross-check left or right orientation from a side-profile photograph, then verify left or right orientation before the installation begins. The maintenance supervisor should inspect opening and hole pattern from a lower-retainer view, then cross-check wheel-arch or lamp clearance before the carton is allocated.

Application Review

Keep protective wrapping in place where possible until the item has passed the initial comparison. Recorded packing is 135 × 6 × 58CM / 1PCS; reconfirm current packing when freight is quoted.

Pre-Order Inspection

A complete sourcing request names the quantity, delivery market and the comparison information used. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Purchase Questions

What is the listed vehicle application?

Application information points to Hyundai I10 ’07 / I10 ’11. A workshop should still compare the removed item and mounting location before ordering.

How is the pictured version best verified?

Use the old component to check bolt and clip locations and opening and hole pattern. Also state the installation side or position in the enquiry.

What information helps confirm availability?

A complete sourcing request names the quantity, delivery market and the comparison information used. Keep each requested product on a separate line when several parts share one shipment.