86530-4H000 Front Bumper Support for Hyundai Starex ’08

Front Bumper Support for Hyundai Starex ’08: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Commercial Request Details

This front bumper support is associated with Hyundai Starex ’08. Retain the complete sequence 86530-4H000 when sending a confirmation request. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Technical Comparison Notes

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

The procurement contact should evaluate overall corner curvature, review bracket and bolt-hole spacing, and evaluate upper edge alignment below the lamps before the fitment decision is signed off. This route applies to the front bumper support shown for Hyundai Starex ’08.

If images accompany the enquiry, include a straight-on view, a fixing-point close-up, and a removed-part overview. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with straight-on view to evaluate overall corner curvature. A second image should show lamp or grille openings from fixing-point close-up. Before the fitment decision is signed off, review upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai Starex ’08 vehicle record.

A body-shop buyer should capture bracket and bolt-hole spacing from a full component outline, then evaluate upper edge alignment below the lamps before the replacement is test-positioned. A vehicle inspector should compare overall corner curvature from a full component outline, then confirm bracket and bolt-hole spacing before the quotation is approved. A collision-repair specialist should capture side-retainer engagement from a straight-on view, then inspect upper edge alignment below the lamps before the carton is allocated. The stock controller should inspect bracket and bolt-hole spacing from a rear mounting view, then compare side-retainer engagement before the replacement is test-positioned.

Pre-Order Inspection

Transfer reusable hardware only after checking that every retainer matches the replacement openings. No packing entry is published here; request current carton and quantity information with the quotation.

Installation Planning

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What model is associated with this replacement part?

This page associates the front bumper support with Hyundai Starex ’08. The vehicle record and original component should agree with the pictured version.

How is the pictured version best verified?

Ask the workshop to inspect overall corner curvature together with lamp or grille openings. VIN or chassis information can clarify market-specific differences.

What information is needed for a quotation?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. This information helps separate technical confirmation from the later shipping calculation.