66400-4F510 Hood for Hyundai H100 / Porter’13 / Starles / Starex

Hood for Hyundai H100 / Porter’13 / Starles / Starex: This page brings the main vehicle, component and comparison details into one sourcing reference. The component belongs to the body inspection group.

Product Specifications

Installation Planning

This hood is associated with Hyundai H100 / Porter’13 / Starles / Starex. Cross-check 66400-4F510 against the removed item, paying attention to every prefix, suffix and character. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Part Recognition Guide

• Wheel-arch or lamp clearance
• Opening and hole pattern
• Left or right orientation
• Panel contour
• Bolt and clip locations

The procurement contact should cross-check wheel-arch or lamp clearance, verify opening and hole pattern, and verify bolt and clip locations before the commercial request is submitted. This route applies to the hood shown for Hyundai H100 / Porter’13 / Starles / Starex.

If images accompany the enquiry, include an upper-edge image, a full component outline, and an installation-opening picture. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with upper-edge image to cross-check wheel-arch or lamp clearance. A second image should show left or right orientation from full component outline. Before the commercial request is submitted, verify bolt and clip locations and note any difference from the removed component. Keep these observations with the Hyundai H100 / Porter’13 / Starles / Starex vehicle record.

The stock controller should review wheel-arch or lamp clearance from a connector close-up, then record wheel-arch or lamp clearance before the commercial request is submitted. A workshop estimator should review wheel-arch or lamp clearance from a side-profile photograph, then photograph opening and hole pattern before the installation begins. The maintenance supervisor should capture wheel-arch or lamp clearance from an installation-opening picture, then measure left or right orientation before the vehicle is dismantled. A body-shop buyer should cross-check panel contour from an upper-edge image, then cross-check wheel-arch or lamp clearance before the replacement is test-positioned.

Vehicle-Side Evidence

Keep protective wrapping in place where possible until the item has passed the initial comparison. Recorded packing is 113 × 38 × 34CM / 5PCS; reconfirm current packing when freight is quoted.

Supply Enquiry Details

Quotation review is faster when quantity, shipping destination and original-part images arrive together. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

Which vehicle record belongs with this product?

This hood is listed for Hyundai H100 / Porter’13 / Starles / Starex. Use that designation as a starting point and verify the vehicle configuration before ordering.

What should a workshop inspect before purchase?

Fitment evidence should show wheel-arch or lamp clearance, left or right orientation and the position where the component will be installed.

What should a distributor send for a quotation?

Quotation review is faster when quantity, shipping destination and original-part images arrive together. Keep each requested product on a separate line when several parts share one shipment.