92401-4F030 / 92402-4F030 Tail Light Assembly for Hyundai H100 / Porter ’04

Tail Light Assembly for Hyundai H100 / Porter ’04: The following information supports a structured pre-order check for trade buyers. The component belongs to the lighting inspection group.

Product Specifications

Ordering Information

This tail light assembly is associated with Hyundai H100 / Porter ’04. Write 92401-4F030 / 92402-4F030 on the inspection sheet and ask the workshop to confirm the same characters on the removed piece. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Reference Check

• Left or right installation position
• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing

The procurement contact should photograph left or right installation position, document clearance beside bumper and grille, and align mounting tabs around the housing before the installation begins. This route applies to the tail light assembly shown for Hyundai H100 / Porter ’04.

If images accompany the enquiry, include a corner-profile view, a chassis-plate image, and an installation-opening picture. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with corner-profile view to photograph left or right installation position. A second image should show lens profile and outer edge from chassis-plate image. Before the installation begins, document mounting tabs around the housing and note any difference from the removed component. Keep these observations with the Hyundai H100 / Porter ’04 vehicle record.

The stock controller should trace clearance beside bumper and grille from a fixing-point close-up, then evaluate left or right installation position before the repair schedule is finalized. A collision-repair specialist should cross-check mounting tabs around the housing from a full component outline, then cross-check clearance beside bumper and grille before the carton is allocated. A workshop estimator should evaluate clearance beside bumper and grille from a vehicle-side photograph, then compare clearance beside bumper and grille before the packing plan is prepared. The installation team should confirm clearance beside bumper and grille from an upper-edge image, then note mounting tabs around the housing before the fitment decision is signed off.

Replacement Selection Guide

A qualified installer should resolve alignment or wiring differences before the vehicle returns to service. Recorded packing is 86 × 42 × 32CM / 10PCS; reconfirm current packing when freight is quoted.

Part Recognition Guide

For a trade enquiry, include required units, delivery location and photographs of the original component. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What model is associated with this replacement part?

The associated model designation is Hyundai H100 / Porter ’04. Confirm the body or electrical configuration relevant to this tail light assembly.

How should fitment be checked before ordering?

Check left or right installation position, confirm lens profile and outer edge, and retain the removed part until the replacement has been compared side by side.

What should a distributor send for a quotation?

For a trade enquiry, include required units, delivery location and photographs of the original component. State the required side or installation position where that detail applies.