86519-2W000 Hook Cap-Front Bumper for Hyundai Santa Fe ’13

Hook Cap-Front Bumper for Hyundai Santa Fe ’13: This page brings the main vehicle, component and comparison details into one sourcing reference. The component belongs to the bumper inspection group.

Product Specifications

Fitment Evidence

This hook cap-front bumper is associated with Hyundai Santa Fe ’13. Use 86519-2W000 as the written lookup reference while also checking geometry and installation position. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Vehicle-Side Evidence

• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings

A collision-repair specialist should evaluate side-retainer engagement, capture upper edge alignment below the lamps, and record lamp or grille openings before the delivery plan is confirmed. This route applies to the hook cap-front bumper shown for Hyundai Santa Fe ’13.

If images accompany the enquiry, include a rear mounting view, a fastener detail, and a side-profile photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A collision-repair specialist can begin with rear mounting view to evaluate side-retainer engagement. A second image should show overall corner curvature from fastener detail. Before the delivery plan is confirmed, capture lamp or grille openings and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’13 vehicle record.

A vehicle inspector should record side-retainer engagement from a connector close-up, then assess lamp or grille openings before the replacement is test-positioned. The importing distributor should note lamp or grille openings from a lower-retainer view, then mark lamp or grille openings before the stock request is released. A workshop estimator should verify upper edge alignment below the lamps from an adjacent-panel image, then record bracket and bolt-hole spacing before the shipment is booked. The service adviser should align lamp or grille openings from an installation-opening picture, then photograph side-retainer engagement before the fitment decision is signed off.

Procurement Checklist

Transfer reusable hardware only after checking that every retainer matches the replacement openings. No packing entry is published here; request current carton and quantity information with the quotation.

Inspection Route

Repair shops should attach vehicle and removed-part evidence when asking for availability and freight. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What is the listed vehicle application?

This hook cap-front bumper appears under Hyundai Santa Fe ’13. Review the exact vehicle version rather than relying on the model name by itself.

Which details help confirm the correct version?

Fitment evidence should show side-retainer engagement, overall corner curvature and the position where the component will be installed.

What information is needed for a quotation?

Repair shops should attach vehicle and removed-part evidence when asking for availability and freight. The supplier can then review the product version, carton requirements and delivery options.