92401-2W130 / 92402-2W130 Tail Light Assembly (LED) for Hyundai Santa Fe ’13

Tail Light Assembly (LED) for Hyundai Santa Fe ’13: This product entry is arranged for workshops and distributors checking a replacement requirement. The component belongs to the lighting inspection group.

Product Specifications

Installation Planning

This tail light assembly (led) is associated with Hyundai Santa Fe ’13. Include 92401-2W130 / 92402-2W130 in a wholesale enquiry so the item can be reviewed against the vehicle data. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Technical Comparison Notes

• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position
• Clearance beside bumper and grille

The parts coordinator should measure lens profile and outer edge, record electrical plug and pin layout, and note clearance beside bumper and grille before the commercial request is submitted. This route applies to the tail light assembly (led) shown for Hyundai Santa Fe ’13.

If images accompany the enquiry, include a corner-profile view, a full component outline, and a straight-on view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The parts coordinator can begin with corner-profile view to measure lens profile and outer edge. A second image should show mounting tabs around the housing from full component outline. Before the commercial request is submitted, record clearance beside bumper and grille and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’13 vehicle record.

The service adviser should confirm mounting tabs around the housing from a rear mounting view, then confirm clearance beside bumper and grille before the installation begins. The receiving technician should assess electrical plug and pin layout from a vehicle-side photograph, then measure clearance beside bumper and grille before the quotation is approved. The receiving technician should confirm clearance beside bumper and grille from a connector close-up, then record left or right installation position before the replacement is test-positioned. The repair planner should verify lens profile and outer edge from a connector close-up, then record left or right installation position before the fitment decision is signed off.

Procurement Checklist

Inspect clips and retainers because worn hardware can affect alignment even when the main part is correct. Recorded packing is 91 × 52 × 57CM / 10PCS; reconfirm current packing when freight is quoted.

Ordering Information

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

What vehicle information should be checked first?

This tail light assembly (led) is listed for Hyundai Santa Fe ’13. Use that designation as a starting point and verify the vehicle configuration before ordering.

What should be compared with the removed component?

Use the old component to check lens profile and outer edge and mounting tabs around the housing. Also state the installation side or position in the enquiry.

How should a wholesale request be submitted?

Send the order volume and destination together with VIN or chassis information where available. Packing and freight can be discussed after the component version has been identified.