86611-3X000 Rear Bumper for Hyundai Elantra ’11 / Elantra ’14

Rear Bumper for Hyundai Elantra ’11 / Elantra ’14: For repair planning, compare the pictured item with the original part before confirming an order. The component belongs to the bumper inspection group.

Product Specifications

Purchase Preparation

This rear bumper is associated with Hyundai Elantra ’11 / Elantra ’14. If 86611-3X000 appears on the original label or casting, continue by confirming holes, clips and clearance. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Buyer Verification Notes

• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing

A workshop estimator should record lamp or grille openings, compare side-retainer engagement, and capture bracket and bolt-hole spacing before the fitment decision is signed off. This route applies to the rear bumper shown for Hyundai Elantra ’11 / Elantra ’14.

If images accompany the enquiry, include an adjacent-panel image, a vehicle-side photograph, and a rear mounting view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A workshop estimator can begin with adjacent-panel image to record lamp or grille openings. A second image should show upper edge alignment below the lamps from vehicle-side photograph. Before the fitment decision is signed off, compare bracket and bolt-hole spacing and note any difference from the removed component. Keep these observations with the Hyundai Elantra ’11 / Elantra ’14 vehicle record.

The parts coordinator should note bracket and bolt-hole spacing from an adjacent-panel image, then record upper edge alignment below the lamps before the installation begins. The procurement contact should capture side-retainer engagement from an adjacent-panel image, then measure bracket and bolt-hole spacing before the installation begins. A vehicle inspector should review bracket and bolt-hole spacing from an original-label photograph, then note overall corner curvature before the installation begins. The receiving technician should cross-check overall corner curvature from an original-label photograph, then note side-retainer engagement before the quotation is approved.

Inspection Route

If the component contacts adjacent panels, pause the work and repeat the fitment comparison. Recorded packing is 200 × 30 × 60CM / 5PCS; reconfirm current packing when freight is quoted.

Vehicle-Side Evidence

Quotation review is faster when quantity, shipping destination and original-part images arrive together. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What vehicle information should be checked first?

This page associates the rear bumper with Hyundai Elantra ’11 / Elantra ’14. The vehicle record and original component should agree with the pictured version.

How should fitment be checked before ordering?

Fitment evidence should show lamp or grille openings, upper edge alignment below the lamps and the position where the component will be installed.

What should a distributor send for a quotation?

Quotation review is faster when quantity, shipping destination and original-part images arrive together. This information helps separate technical confirmation from the later shipping calculation.