Front Bumper Version B for Daewoo N300 / N400 / Cerato ’05

Front Bumper Version B for Daewoo N300 / N400 / Cerato ’05: This component should be selected through a combined check of reference data and visible geometry. The component belongs to the bumper inspection group.

Product Specifications

Supply Enquiry Details

This front bumper version b is associated with Daewoo N300 / N400 / Cerato ’05. Use a side-by-side shape comparison in place of an invented reference number. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Workshop Comparison

• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature

A body-shop buyer should cross-check bracket and bolt-hole spacing, align lamp or grille openings, and confirm overall corner curvature before the quotation is approved. This route applies to the front bumper version b shown for Daewoo N300 / N400 / Cerato ’05.

If images accompany the enquiry, include a full component outline, a lower-retainer view, and an original-label photograph. Label the evidence with the vehicle designation Daewoo N300 / N400 / Cerato ’05 so the workshop and purchasing team review one configuration.

A body-shop buyer can begin with full component outline to cross-check bracket and bolt-hole spacing. A second image should show side-retainer engagement from lower-retainer view. Before the quotation is approved, align overall corner curvature and note any difference from the removed component. Keep these observations with the Daewoo N300 / N400 / Cerato ’05 vehicle record.

The installation team should inspect upper edge alignment below the lamps from a rear mounting view, then note lamp or grille openings before the repair schedule is finalized. The stock controller should align bracket and bolt-hole spacing from a removed-part overview, then mark upper edge alignment below the lamps before the fitment decision is signed off. A vehicle inspector should verify bracket and bolt-hole spacing from a straight-on view, then compare overall corner curvature before the repair schedule is finalized. A body-shop buyer should measure upper edge alignment below the lamps from a straight-on view, then capture lamp or grille openings before the shipment is booked.

Component Matching Record

Place old and replacement components side by side, then review every fixing point before installation. No packing entry is published here; request current carton and quantity information with the quotation.

Purchase Preparation

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Frequently Asked Questions

What is the listed vehicle application?

The listing covers Daewoo N300 / N400 / Cerato ’05. Because configurations may vary, check the actual installation area before approving the front bumper version b.

What should a workshop inspect before purchase?

Use the old component to check bracket and bolt-hole spacing and side-retainer engagement. Also state the installation side or position in the enquiry.

What should a distributor send for a quotation?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Providing the vehicle record at the start reduces follow-up questions during quotation.