Outer Tail Light Assembly Version B for KIA Bongo’19 / Sumsung / Banggo ’98

This supply page covers a outer tail light assembly version b linked with KIA Bongo’19 / Sumsung / Banggo ’98. Before pricing or shipment is finalized, match the photographed version to the removed part and its surrounding installation area.

KIA Product Data

This corner-lamp entry for KIA Bongo 2019 / Sumsung / Banggo 1998 carries the source markings 060C-51-070 for the right side and 060C-51-060 for the left side. Lay the two lamps in vehicle orientation and label their positions before photographing the lens face, rear housing, bulb access, connector area and mounting studs. Compare the pointed outer corner, body-facing edge and reflector segmentation with the removed lamp. At the vehicle, record the opening beside the headlamp and grille and measure the distance between the main retainers. Do not select the lamp from the general vehicle name alone, because commercial-body repairs and regional configurations can change the installed version. During a loose positioning check, confirm that the lens follows the adjacent panel line and that the rear housing clears the harness without pressure. Send the visible reference markings, required side or pair, order quantity, delivery country and complete photo set with the quotation request. Ask for protective separation between left and right lenses inside the export carton.

Vehicle Designation and Position

This item has no stated OE reference. Use the component image and the original part as the primary evidence, supported by the KIA model designation and vehicle record.

This component is grouped under KIA Bongo’19 / Sumsung / Banggo ’98. Confirm orientation and the vehicle-side configuration.

Component Recognition Points

Compare left or right installation position at the vehicle, then review clearance beside bumper and grille on the bench. Record any difference in lens profile and outer edge and send that note with the enquiry.

• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing

Workshop Trial-Fit Plan

Before permanent assembly, place the item loosely in position and engage only the primary locators. The technician should confirm consistent alignment, unrestricted adjacent movement and correct access to service points.

A loose positioning check should confirm electrical plug and pin layout without conflict at clearance beside bumper and grille.

Availability and Packing Request

Separate technical confirmation from freight calculation: first approve the pictured configuration, then provide volume and destination for commercial terms. This reduces confusion when similar KIA parts share a model label.

The recorded packing reference is 61 × 35 × 33CM / 20PCS; ask for confirmation when the shipment quantity and destination are known.

Frequently Asked Questions

Which KIA application is shown for this product?

This outer tail light assembly version b is catalogued for KIA Bongo’19 / Sumsung / Banggo ’98; check the vehicle configuration as well.

Which physical details should a workshop compare?

Vehicle-side evidence should cover mounting tabs around the housing, clearance beside bumper and grille and lens profile and outer edge.

Which details are needed for a B2B quotation?

Submit the OE reference when available, together with quantity and delivery point.