92403-2B000 / 92404-2B000 Tail Light Assembly for Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08

Tail Light Assembly for Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08: The following information supports a structured pre-order check for trade buyers. The component belongs to the lighting inspection group.

Product Specifications

Vehicle-Side Evidence

This tail light assembly is associated with Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08. The references 92403-2B000 / 92404-2B000 support identification but do not replace a physical comparison. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Fitment Evidence

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The maintenance supervisor should document clearance beside bumper and grille, note lens profile and outer edge, and cross-check left or right installation position before the quotation is approved. This route applies to the tail light assembly shown for Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08.

If images accompany the enquiry, include an adjacent-panel image, a fixing-point close-up, and a fastener detail. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The maintenance supervisor can begin with adjacent-panel image to document clearance beside bumper and grille. A second image should show electrical plug and pin layout from fixing-point close-up. Before the quotation is approved, note left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08 vehicle record.

The service adviser should trace electrical plug and pin layout from a fastener detail, then cross-check lens profile and outer edge before the fitment decision is signed off. The procurement contact should align left or right installation position from a corner-profile view, then evaluate electrical plug and pin layout before the stock request is released. The procurement contact should mark electrical plug and pin layout from a chassis-plate image, then measure electrical plug and pin layout before the replacement is test-positioned. The maintenance supervisor should review left or right installation position from a lower-retainer view, then measure lens profile and outer edge before the repair schedule is finalized.

Inspection Route

Photograph the original arrangement before removal when several brackets or connectors are involved. Recorded packing is 67 × 32 × 54CM / 10PCS; reconfirm current packing when freight is quoted.

Configuration Check

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Common Workshop Questions

Which vehicle is this component listed for?

Application information points to Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08. A workshop should still compare the removed item and mounting location before ordering.

What should be compared with the removed component?

Ask the workshop to inspect clearance beside bumper and grille together with electrical plug and pin layout. VIN or chassis information can clarify market-specific differences.

What should be included in a B2B enquiry?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. State the required side or installation position where that detail applies.