92401-B4000 / 92402-B4000 Tail Light Assembly for Hyundai I10 ‘2014 / I10 ‘2017

Tail Light Assembly for Hyundai I10 ‘2014 / I10 ‘2017: The following information supports a structured pre-order check for trade buyers. The component belongs to the lighting inspection group.

Product Specifications

Buyer Verification Notes

This tail light assembly is associated with Hyundai I10 ‘2014 / I10 ‘2017. Compare 92401-B4000 / 92402-B4000 character by character with the marking on the removed component. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Application Review

• Left or right installation position
• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing

The procurement contact should document left or right installation position, capture clearance beside bumper and grille, and assess mounting tabs around the housing before the fitment decision is signed off. This route applies to the tail light assembly shown for Hyundai I10 ‘2014 / I10 ‘2017.

If images accompany the enquiry, include an installation-opening picture, a chassis-plate image, and a straight-on view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with installation-opening picture to document left or right installation position. A second image should show lens profile and outer edge from chassis-plate image. Before the fitment decision is signed off, capture mounting tabs around the housing and note any difference from the removed component. Keep these observations with the Hyundai I10 ‘2014 / I10 ‘2017 vehicle record.

The procurement contact should trace clearance beside bumper and grille from a side-profile photograph, then review clearance beside bumper and grille before the repair schedule is finalized. A collision-repair specialist should capture mounting tabs around the housing from a fixing-point close-up, then confirm mounting tabs around the housing before the purchase order is issued. A collision-repair specialist should measure clearance beside bumper and grille from a chassis-plate image, then confirm mounting tabs around the housing before the commercial request is submitted. The procurement contact should compare clearance beside bumper and grille from a straight-on view, then confirm lens profile and outer edge before the vehicle is dismantled.

Reference Check

Inspect clips and retainers because worn hardware can affect alignment even when the main part is correct. Recorded packing is 90 × 51 × 63CM / 8PCS; reconfirm current packing when freight is quoted.

Replacement Selection Guide

A complete sourcing request names the quantity, delivery market and the comparison information used. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

How should the model application be interpreted?

This page associates the tail light assembly with Hyundai I10 ‘2014 / I10 ‘2017. The vehicle record and original component should agree with the pictured version.

What should be compared with the removed component?

Ask the workshop to inspect left or right installation position together with lens profile and outer edge. VIN or chassis information can clarify market-specific differences.

What should be included in a B2B enquiry?

A complete sourcing request names the quantity, delivery market and the comparison information used. Packing and freight can be discussed after the component version has been identified.