92401-0X110 / 92402-0X110 Tail Light Assembly for Hyundai I10 ’07 / I10 ’11

Tail Light Assembly for Hyundai I10 ’07 / I10 ’11: This component should be selected through a combined check of reference data and visible geometry. The component belongs to the lighting inspection group.

Product Specifications

Purchase Preparation

This tail light assembly is associated with Hyundai I10 ’07 / I10 ’11. Retain the complete sequence 92401-0X110 / 92402-0X110 when sending a confirmation request. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Application Review

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The repair planner should confirm clearance beside bumper and grille, confirm lens profile and outer edge, and cross-check left or right installation position before the installation begins. This route applies to the tail light assembly shown for Hyundai I10 ’07 / I10 ’11.

If images accompany the enquiry, include an upper-edge image, a vehicle-side photograph, and a rear mounting view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The repair planner can begin with upper-edge image to confirm clearance beside bumper and grille. A second image should show electrical plug and pin layout from vehicle-side photograph. Before the installation begins, confirm left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai I10 ’07 / I10 ’11 vehicle record.

The importing distributor should trace clearance beside bumper and grille from a removed-part overview, then document clearance beside bumper and grille before the repair schedule is finalized. The maintenance supervisor should record electrical plug and pin layout from an adjacent-panel image, then verify clearance beside bumper and grille before the repair schedule is finalized. The service adviser should document left or right installation position from a straight-on view, then review mounting tabs around the housing before the quotation is approved. A workshop estimator should evaluate lens profile and outer edge from an installation-opening picture, then mark electrical plug and pin layout before the fitment decision is signed off.

Fitment Evidence

Retain the removed part until the replacement has been visually compared and test-positioned. Recorded packing is 79 × 50 × 51CM / 10PCS; reconfirm current packing when freight is quoted.

Procurement Checklist

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Common Workshop Questions

Which vehicle is this component listed for?

The associated model designation is Hyundai I10 ’07 / I10 ’11. Confirm the body or electrical configuration relevant to this tail light assembly.

What evidence is useful for a fitment review?

Fitment evidence should show clearance beside bumper and grille, electrical plug and pin layout and the position where the component will be installed.

What should be included in a B2B enquiry?

Send the order volume and destination together with VIN or chassis information where available. State the required side or installation position where that detail applies.