86651-K6000 / 86652-K6000 Rear Bumper Bracket for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d

Rear Bumper Bracket for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d: Match the item to the vehicle configuration before quantity and shipping terms are confirmed. The component belongs to the bumper inspection group.

Product Specifications

Physical Fitment Points

This rear bumper bracket is associated with Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d. The OEM entry 86651-K6000 / 86652-K6000 supplies a searchable identifier and should agree with the original marking. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Buyer Verification Notes

• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings

The installation team should photograph side-retainer engagement, confirm upper edge alignment below the lamps, and align lamp or grille openings before the replacement is test-positioned. This route applies to the rear bumper bracket shown for Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d.

If images accompany the enquiry, include an original-label photograph, an original-label photograph, and a side-profile photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The installation team can begin with original-label photograph to photograph side-retainer engagement. A second image should show overall corner curvature from original-label photograph. Before the replacement is test-positioned, confirm lamp or grille openings and note any difference from the removed component. Keep these observations with the Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d vehicle record.

The maintenance supervisor should verify side-retainer engagement from a connector close-up, then confirm overall corner curvature before the packing plan is prepared. The importing distributor should evaluate lamp or grille openings from an underside image, then measure overall corner curvature before the commercial request is submitted. A body-shop buyer should inspect bracket and bolt-hole spacing from a fastener detail, then document overall corner curvature before the replacement is test-positioned. A collision-repair specialist should compare overall corner curvature from a fastener detail, then record overall corner curvature before the delivery plan is confirmed.

Replacement Selection Guide

Confirm left and right orientation at the vehicle rather than relying on a mirrored product photograph. No packing entry is published here; request current carton and quantity information with the quotation.

Application Review

Quotation review is faster when quantity, shipping destination and original-part images arrive together. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

What vehicle information should be checked first?

The associated model designation is Hyundai Grand I10 ’21 / Nios 5d / Grand I10 ’21 4d. Confirm the body or electrical configuration relevant to this rear bumper bracket.

What should a workshop inspect before purchase?

Check side-retainer engagement, confirm overall corner curvature, and retain the removed part until the replacement has been compared side by side.

What should a distributor send for a quotation?

Quotation review is faster when quantity, shipping destination and original-part images arrive together. This information helps separate technical confirmation from the later shipping calculation.