86561-3S500 Front Bumper Grille for Hyundai Sonata ’11-’13

Front Bumper Grille for Hyundai Sonata ’11-’13: A reliable quotation starts with a clear component description and physical comparison evidence. The component belongs to the bumper inspection group.

Product Specifications

Ordering Information

This front bumper grille is associated with Hyundai Sonata ’11-’13. For purchasing documents, quote 86561-3S500 exactly and add the destination market and vehicle information. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Component Matching Record

• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement

A workshop estimator should cross-check upper edge alignment below the lamps, note overall corner curvature, and mark side-retainer engagement before the carton is allocated. This route applies to the front bumper grille shown for Hyundai Sonata ’11-’13.

If images accompany the enquiry, include an installation-opening picture, a rear mounting view, and a lower-retainer view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A workshop estimator can begin with installation-opening picture to cross-check upper edge alignment below the lamps. A second image should show bracket and bolt-hole spacing from rear mounting view. Before the carton is allocated, note side-retainer engagement and note any difference from the removed component. Keep these observations with the Hyundai Sonata ’11-’13 vehicle record.

The importing distributor should note lamp or grille openings from a vehicle-side photograph, then note lamp or grille openings before the installation begins. The maintenance supervisor should compare bracket and bolt-hole spacing from a vehicle-side photograph, then compare overall corner curvature before the commercial request is submitted. The importing distributor should assess overall corner curvature from a corner-profile view, then measure bracket and bolt-hole spacing before the quotation is approved. The service adviser should confirm side-retainer engagement from a chassis-plate image, then mark bracket and bolt-hole spacing before the commercial request is submitted.

Procurement Checklist

Keep protective wrapping in place where possible until the item has passed the initial comparison. No packing entry is published here; request current carton and quantity information with the quotation.

Reference Check

For a trade enquiry, include required units, delivery location and photographs of the original component. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

Which vehicle is this component listed for?

This front bumper grille is listed for Hyundai Sonata ’11-’13. Use that designation as a starting point and verify the vehicle configuration before ordering.

What should be compared with the removed component?

Photograph upper edge alignment below the lamps and the mounting area around bracket and bolt-hole spacing. Combine those images with vehicle identification data for review.

What should a distributor send for a quotation?

For a trade enquiry, include required units, delivery location and photographs of the original component. State the required side or installation position where that detail applies.