86513-B4000 / 86514-B4000 Front Bumper Brackret for Hyundai I10 ‘2014

Front Bumper Brackret for Hyundai I10 ‘2014: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Application Review

This front bumper brackret is associated with Hyundai I10 ‘2014. The OEM entry 86513-B4000 / 86514-B4000 supplies a searchable identifier and should agree with the original marking. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Buyer Verification Notes

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

The receiving technician should mark overall corner curvature, compare bracket and bolt-hole spacing, and trace upper edge alignment below the lamps before the carton is allocated. This route applies to the front bumper brackret shown for Hyundai I10 ‘2014.

If images accompany the enquiry, include a rear mounting view, an adjacent-panel image, and an original-label photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The receiving technician can begin with rear mounting view to mark overall corner curvature. A second image should show lamp or grille openings from adjacent-panel image. Before the carton is allocated, compare upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai I10 ‘2014 vehicle record.

The importing distributor should document upper edge alignment below the lamps from a chassis-plate image, then trace side-retainer engagement before the replacement is test-positioned. The importing distributor should cross-check bracket and bolt-hole spacing from a full component outline, then photograph overall corner curvature before the quotation is approved. A vehicle inspector should capture upper edge alignment below the lamps from an underside image, then inspect overall corner curvature before the purchase order is issued. The parts coordinator should record side-retainer engagement from a connector close-up, then note side-retainer engagement before the quotation is approved.

Pre-Order Inspection

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. No packing entry is published here; request current carton and quantity information with the quotation.

Reference Check

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

Which vehicle is this component listed for?

Application information points to Hyundai I10 ‘2014. A workshop should still compare the removed item and mounting location before ordering.

What should be compared with the removed component?

Use the old component to check overall corner curvature and lamp or grille openings. Also state the installation side or position in the enquiry.

What information helps confirm availability?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. State the required side or installation position where that detail applies.