86511-4H700 Front Bumper for Hyundai Starex ’18 / H1 / Tucson

Front Bumper for Hyundai Starex ’18 / H1 / Tucson: This component should be selected through a combined check of reference data and visible geometry. The component belongs to the bumper inspection group.

Product Specifications

Purchase Preparation

This front bumper is associated with Hyundai Starex ’18 / H1 / Tucson. Cross-check 86511-4H700 against the removed item, paying attention to every prefix, suffix and character. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Workshop Comparison

• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings

The installation team should record side-retainer engagement, note upper edge alignment below the lamps, and note lamp or grille openings before the packing plan is prepared. This route applies to the front bumper shown for Hyundai Starex ’18 / H1 / Tucson.

If images accompany the enquiry, include a straight-on view, a corner-profile view, and an original-label photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The installation team can begin with straight-on view to record side-retainer engagement. A second image should show overall corner curvature from corner-profile view. Before the packing plan is prepared, note lamp or grille openings and note any difference from the removed component. Keep these observations with the Hyundai Starex ’18 / H1 / Tucson vehicle record.

A workshop estimator should confirm bracket and bolt-hole spacing from an upper-edge image, then trace upper edge alignment below the lamps before the vehicle is dismantled. The procurement contact should compare bracket and bolt-hole spacing from a vehicle-side photograph, then inspect lamp or grille openings before the replacement is test-positioned. A workshop estimator should compare lamp or grille openings from a fastener detail, then document overall corner curvature before the quotation is approved. A workshop estimator should cross-check lamp or grille openings from a fixing-point close-up, then measure lamp or grille openings before the purchase order is issued.

Commercial Request Details

Keep protective wrapping in place where possible until the item has passed the initial comparison. No packing entry is published here; request current carton and quantity information with the quotation.

Inspection Route

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Purchase Questions

How should the model application be interpreted?

Application information points to Hyundai Starex ’18 / H1 / Tucson. A workshop should still compare the removed item and mounting location before ordering.

What should a workshop inspect before purchase?

Use the old component to check side-retainer engagement and overall corner curvature. Also state the installation side or position in the enquiry.

What information is needed for a quotation?

Send the order volume and destination together with VIN or chassis information where available. Packing and freight can be discussed after the component version has been identified.