96549084 Hood for Daewoo Nubira / Lacetti ’03 / Optra

Hood for Daewoo Nubira / Lacetti ’03 / Optra: Parts selection should begin with the removed component and the exact vehicle record. The component belongs to the body inspection group.

Product Specifications

Component Matching Record

This hood is associated with Daewoo Nubira / Lacetti ’03 / Optra. Reference matching begins with 96549084; finish the check by examining the outline and fixing points. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Repair Planning Notes

• Left or right orientation
• Panel contour
• Bolt and clip locations
• Wheel-arch or lamp clearance
• Opening and hole pattern

The repair planner should mark left or right orientation, cross-check panel contour, and cross-check opening and hole pattern before the replacement is test-positioned. This route applies to the hood shown for Daewoo Nubira / Lacetti ’03 / Optra.

If images accompany the enquiry, include an original-label photograph, a corner-profile view, and a fixing-point close-up. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The repair planner can begin with original-label photograph to mark left or right orientation. A second image should show bolt and clip locations from corner-profile view. Before the replacement is test-positioned, cross-check opening and hole pattern and note any difference from the removed component. Keep these observations with the Daewoo Nubira / Lacetti ’03 / Optra vehicle record.

A workshop estimator should verify opening and hole pattern from an installation-opening picture, then compare bolt and clip locations before the quotation is approved. The parts coordinator should document opening and hole pattern from an underside image, then compare opening and hole pattern before the replacement is test-positioned. The receiving technician should cross-check bolt and clip locations from a removed-part overview, then photograph opening and hole pattern before the commercial request is submitted. The maintenance supervisor should trace bolt and clip locations from an installation-opening picture, then align panel contour before the fitment decision is signed off.

Pre-Order Inspection

Trial-position the component with nearby trim loosened only as required by workshop procedure. Recorded packing is 138 × 120 × 12CM / 1PCS; reconfirm current packing when freight is quoted.

Supply Enquiry Details

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

What vehicle information should be checked first?

The listing covers Daewoo Nubira / Lacetti ’03 / Optra. Because configurations may vary, check the actual installation area before approving the hood.

How can an incorrect order be avoided?

Ask the workshop to inspect left or right orientation together with bolt and clip locations. VIN or chassis information can clarify market-specific differences.

What should be included in a B2B enquiry?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. State the required side or installation position where that detail applies.