Rear Bumper for Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00

Rear Bumper for Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00: Parts selection should begin with the removed component and the exact vehicle record. The component belongs to the bumper inspection group.

Product Specifications

Repair Planning Notes

This rear bumper is associated with Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00. Fitment review should begin with the vehicle and continue with holes, clips and surrounding clearance. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Vehicle-Side Evidence

• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement

The importing distributor should record upper edge alignment below the lamps, note overall corner curvature, and compare side-retainer engagement before the shipment is booked. This route applies to the rear bumper shown for Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00.

If images accompany the enquiry, include a rear mounting view, a fixing-point close-up, and an upper-edge image. Label the evidence with the vehicle designation Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00 so the workshop and purchasing team review one configuration.

The importing distributor can begin with rear mounting view to record upper edge alignment below the lamps. A second image should show bracket and bolt-hole spacing from fixing-point close-up. Before the shipment is booked, note side-retainer engagement and note any difference from the removed component. Keep these observations with the Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00 vehicle record.

A body-shop buyer should mark bracket and bolt-hole spacing from a fixing-point close-up, then assess bracket and bolt-hole spacing before the fitment decision is signed off. The importing distributor should inspect bracket and bolt-hole spacing from an original-label photograph, then inspect lamp or grille openings before the purchase order is issued. The service adviser should confirm bracket and bolt-hole spacing from a rear mounting view, then trace upper edge alignment below the lamps before the installation begins. A body-shop buyer should cross-check overall corner curvature from a lower-retainer view, then trace lamp or grille openings before the purchase order is issued.

Ordering Information

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. No packing entry is published here; request current carton and quantity information with the quotation.

Component Matching Record

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Frequently Asked Questions

What vehicle information should be checked first?

The stated vehicle is Daewoo Magnus ’07 / Nubira ’97 / Nubira ’00. Treat that model label as one part of the fitment check, together with photographs and chassis details.

What should be compared with the removed component?

Ask the workshop to inspect upper edge alignment below the lamps together with bracket and bolt-hole spacing. VIN or chassis information can clarify market-specific differences.

What should a distributor send for a quotation?

Send the order volume and destination together with VIN or chassis information where available. Providing the vehicle record at the start reduces follow-up questions during quotation.