Tail Light Assembly – Single Triangular Multi-Lens Unit for Daewoo Aveo ’04 / Aveo ’05

Tail Light Assembly – Single Triangular Multi-Lens Unit for Daewoo Aveo ’04 / Aveo ’05: A reliable quotation starts with a clear component description and physical comparison evidence. The component belongs to the lighting inspection group.

Product Specifications

Inspection Route

This tail light assembly – single triangular multi-lens unit is associated with Daewoo Aveo ’04 / Aveo ’05. No OEM identifier has been added; the buyer should send vehicle data and original-part photographs. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Repair Planning Notes

• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position
• Clearance beside bumper and grille

The procurement contact should capture lens profile and outer edge, align electrical plug and pin layout, and photograph clearance beside bumper and grille before the installation begins. This route applies to the tail light assembly – single triangular multi-lens unit shown for Daewoo Aveo ’04 / Aveo ’05.

If images accompany the enquiry, include an installation-opening picture, a vehicle-side photograph, and a rear mounting view. Label the evidence with the vehicle designation Daewoo Aveo ’04 / Aveo ’05 so the workshop and purchasing team review one configuration.

The procurement contact can begin with installation-opening picture to capture lens profile and outer edge. A second image should show mounting tabs around the housing from vehicle-side photograph. Before the installation begins, align clearance beside bumper and grille and note any difference from the removed component. Keep these observations with the Daewoo Aveo ’04 / Aveo ’05 vehicle record.

The installation team should verify clearance beside bumper and grille from a fixing-point close-up, then align left or right installation position before the stock request is released. The parts coordinator should record mounting tabs around the housing from a lower-retainer view, then record left or right installation position before the quotation is approved. A body-shop buyer should trace lens profile and outer edge from a side-profile photograph, then capture mounting tabs around the housing before the packing plan is prepared. The receiving technician should verify left or right installation position from a removed-part overview, then measure mounting tabs around the housing before the carton is allocated.

Physical Fitment Points

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 73 × 45 × 65CM / 8PCS; reconfirm current packing when freight is quoted.

Replacement Selection Guide

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What is the listed vehicle application?

The stated vehicle is Daewoo Aveo ’04 / Aveo ’05. Treat that model label as one part of the fitment check, together with photographs and chassis details.

How should fitment be checked before ordering?

Compare lens profile and outer edge, mounting tabs around the housing and the required installation position with the removed component. VIN or chassis details add another useful check.

What should a distributor send for a quotation?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Providing the vehicle record at the start reduces follow-up questions during quotation.