42671917 / 42671918 Fog Light Led for Daewoo Spark ’18 Ng / Spark ’18 Beat

Fog Light Led for Daewoo Spark ’18 Ng / Spark ’18 Beat: For repair planning, compare the pictured item with the original part before confirming an order. The component belongs to the lighting inspection group.

Product Specifications

Buyer Verification Notes

This fog light led is associated with Daewoo Spark ’18 Ng / Spark ’18 Beat. Use 42671917 / 42671918 as the written lookup reference while also checking geometry and installation position. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Replacement Selection Guide

• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position
• Clearance beside bumper and grille

The parts coordinator should inspect lens profile and outer edge, review electrical plug and pin layout, and photograph clearance beside bumper and grille before the shipment is booked. This route applies to the fog light led shown for Daewoo Spark ’18 Ng / Spark ’18 Beat.

If images accompany the enquiry, include a lower-retainer view, an adjacent-panel image, and a rear mounting view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The parts coordinator can begin with lower-retainer view to inspect lens profile and outer edge. A second image should show mounting tabs around the housing from adjacent-panel image. Before the shipment is booked, review clearance beside bumper and grille and note any difference from the removed component. Keep these observations with the Daewoo Spark ’18 Ng / Spark ’18 Beat vehicle record.

The procurement contact should evaluate electrical plug and pin layout from a vehicle-side photograph, then capture lens profile and outer edge before the commercial request is submitted. A body-shop buyer should inspect lens profile and outer edge from a connector close-up, then mark electrical plug and pin layout before the purchase order is issued. The receiving technician should note electrical plug and pin layout from a corner-profile view, then photograph mounting tabs around the housing before the delivery plan is confirmed. The stock controller should assess electrical plug and pin layout from a straight-on view, then evaluate electrical plug and pin layout before the fitment decision is signed off.

Purchase Preparation

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 73 × 38 × 53.5 / 10PCS; reconfirm current packing when freight is quoted.

Reference Check

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Product Questions and Answers

What is the listed vehicle application?

The stated vehicle is Daewoo Spark ’18 Ng / Spark ’18 Beat. Treat that model label as one part of the fitment check, together with photographs and chassis details.

What should be compared with the removed component?

Compare lens profile and outer edge, mounting tabs around the housing and the required installation position with the removed component. VIN or chassis details add another useful check.

What should be included in a B2B enquiry?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. State the required side or installation position where that detail applies.