42671890 Front Bumper for Daewoo Spark ’18 Ng / Spark ’18 Beat

Front Bumper for Daewoo Spark ’18 Ng / Spark ’18 Beat: This product entry is arranged for workshops and distributors checking a replacement requirement. The component belongs to the bumper inspection group.

Product Specifications

Inspection Route

This front bumper is associated with Daewoo Spark ’18 Ng / Spark ’18 Beat. The references 42671890 support identification but do not replace a physical comparison. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Configuration Check

• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing

The installation team should align lamp or grille openings, cross-check side-retainer engagement, and compare bracket and bolt-hole spacing before the commercial request is submitted. This route applies to the front bumper shown for Daewoo Spark ’18 Ng / Spark ’18 Beat.

If images accompany the enquiry, include a fastener detail, a connector close-up, and a fixing-point close-up. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The installation team can begin with fastener detail to align lamp or grille openings. A second image should show upper edge alignment below the lamps from connector close-up. Before the commercial request is submitted, cross-check bracket and bolt-hole spacing and note any difference from the removed component. Keep these observations with the Daewoo Spark ’18 Ng / Spark ’18 Beat vehicle record.

The installation team should mark side-retainer engagement from a corner-profile view, then cross-check overall corner curvature before the vehicle is dismantled. A collision-repair specialist should verify upper edge alignment below the lamps from a connector close-up, then confirm overall corner curvature before the fitment decision is signed off. A vehicle inspector should confirm lamp or grille openings from a removed-part overview, then record bracket and bolt-hole spacing before the delivery plan is confirmed. The installation team should document lamp or grille openings from a connector close-up, then align overall corner curvature before the replacement is test-positioned.

Installation Planning

Transfer reusable hardware only after checking that every retainer matches the replacement openings. No packing entry is published here; request current carton and quantity information with the quotation.

Workshop Comparison

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

Which vehicle is this component listed for?

The stated vehicle is Daewoo Spark ’18 Ng / Spark ’18 Beat. Treat that model label as one part of the fitment check, together with photographs and chassis details.

Which details help confirm the correct version?

The practical checks are lamp or grille openings, upper edge alignment below the lamps and the surrounding clearance. Avoid choosing the item from the model name alone.

What should a distributor send for a quotation?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. State the required side or installation position where that detail applies.