96687084 Rear Bumper Absorber for Daewoo Matiz-Iv ’09

Rear Bumper Absorber for Daewoo Matiz-Iv ’09: Review the identification points below before adding this component to a repair estimate. The component belongs to the bumper inspection group.

Product Specifications

Workshop Comparison

This rear bumper absorber is associated with Daewoo Matiz-Iv ’09. The references 96687084 support identification but do not replace a physical comparison. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Technical Comparison Notes

• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings

The procurement contact should photograph side-retainer engagement, document upper edge alignment below the lamps, and inspect lamp or grille openings before the fitment decision is signed off. This route applies to the rear bumper absorber shown for Daewoo Matiz-Iv ’09.

If images accompany the enquiry, include a rear mounting view, a full component outline, and a side-profile photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with rear mounting view to photograph side-retainer engagement. A second image should show overall corner curvature from full component outline. Before the fitment decision is signed off, document lamp or grille openings and note any difference from the removed component. Keep these observations with the Daewoo Matiz-Iv ’09 vehicle record.

The receiving technician should mark lamp or grille openings from a vehicle-side photograph, then compare bracket and bolt-hole spacing before the vehicle is dismantled. The service adviser should record lamp or grille openings from a chassis-plate image, then measure lamp or grille openings before the delivery plan is confirmed. A vehicle inspector should note upper edge alignment below the lamps from a lower-retainer view, then note upper edge alignment below the lamps before the carton is allocated. The repair planner should confirm bracket and bolt-hole spacing from an underside image, then trace overall corner curvature before the commercial request is submitted.

Installation Planning

Retain the removed part until the replacement has been visually compared and test-positioned. No packing entry is published here; request current carton and quantity information with the quotation.

Inspection Route

For a trade enquiry, include required units, delivery location and photographs of the original component. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Frequently Asked Questions

Which vehicle is this component listed for?

The recorded application is Daewoo Matiz-Iv ’09. Confirm trim, market specification and the removed rear bumper absorber before purchase.

How is the pictured version best verified?

Ask the workshop to inspect side-retainer engagement together with overall corner curvature. VIN or chassis information can clarify market-specific differences.

What information helps confirm availability?

For a trade enquiry, include required units, delivery location and photographs of the original component. Packing and freight can be discussed after the component version has been identified.