86511-B4500 Front Bumper for Hyundai I10 ‘2014 / I10 ‘2017

Front Bumper for Hyundai I10 ‘2014 / I10 ‘2017: Parts selection should begin with the removed component and the exact vehicle record. The component belongs to the bumper inspection group.

Product Specifications

Application Review

This front bumper is associated with Hyundai I10 ‘2014 / I10 ‘2017. Write 86511-B4500 on the inspection sheet and ask the workshop to confirm the same characters on the removed piece. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Buyer Verification Notes

• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing

A vehicle inspector should align lamp or grille openings, compare side-retainer engagement, and review bracket and bolt-hole spacing before the delivery plan is confirmed. This route applies to the front bumper shown for Hyundai I10 ‘2014 / I10 ‘2017.

If images accompany the enquiry, include a chassis-plate image, a vehicle-side photograph, and a lower-retainer view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A vehicle inspector can begin with chassis-plate image to align lamp or grille openings. A second image should show upper edge alignment below the lamps from vehicle-side photograph. Before the delivery plan is confirmed, compare bracket and bolt-hole spacing and note any difference from the removed component. Keep these observations with the Hyundai I10 ‘2014 / I10 ‘2017 vehicle record.

A body-shop buyer should align upper edge alignment below the lamps from a side-profile photograph, then photograph side-retainer engagement before the fitment decision is signed off. The importing distributor should align side-retainer engagement from an underside image, then photograph upper edge alignment below the lamps before the repair schedule is finalized. The service adviser should record lamp or grille openings from a full component outline, then note overall corner curvature before the replacement is test-positioned. The receiving technician should capture bracket and bolt-hole spacing from an underside image, then review bracket and bolt-hole spacing before the quotation is approved.

Replacement Selection Guide

If the component contacts adjacent panels, pause the work and repeat the fitment comparison. No packing entry is published here; request current carton and quantity information with the quotation.

Supply Enquiry Details

A complete sourcing request names the quantity, delivery market and the comparison information used. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

Which Hyundai model does this page cover?

The listing covers Hyundai I10 ‘2014 / I10 ‘2017. Because configurations may vary, check the actual installation area before approving the front bumper.

What should a workshop inspect before purchase?

Ask the workshop to inspect lamp or grille openings together with upper edge alignment below the lamps. VIN or chassis information can clarify market-specific differences.

What information is needed for a quotation?

A complete sourcing request names the quantity, delivery market and the comparison information used. State the required side or installation position where that detail applies.