Tail Light Assembly for Hyundai I10 ’07 / I10 ’11

Tail Light Assembly for Hyundai I10 ’07 / I10 ’11: The following information supports a structured pre-order check for trade buyers. The component belongs to the lighting inspection group.

Product Specifications

Part Recognition Guide

This tail light assembly is associated with Hyundai I10 ’07 / I10 ’11. This entry carries no OEM number, making physical comparison especially important before ordering. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Installation Planning

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The importing distributor should measure clearance beside bumper and grille, capture lens profile and outer edge, and confirm left or right installation position before the commercial request is submitted. This route applies to the tail light assembly shown for Hyundai I10 ’07 / I10 ’11.

If images accompany the enquiry, include a full component outline, a straight-on view, and a side-profile photograph. Label the evidence with the vehicle designation Hyundai I10 ’07 / I10 ’11 so the workshop and purchasing team review one configuration.

The importing distributor can begin with full component outline to measure clearance beside bumper and grille. A second image should show electrical plug and pin layout from straight-on view. Before the commercial request is submitted, capture left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai I10 ’07 / I10 ’11 vehicle record.

A collision-repair specialist should mark mounting tabs around the housing from an underside image, then cross-check electrical plug and pin layout before the delivery plan is confirmed. A body-shop buyer should cross-check lens profile and outer edge from an installation-opening picture, then align mounting tabs around the housing before the quotation is approved. The procurement contact should inspect clearance beside bumper and grille from an original-label photograph, then cross-check lens profile and outer edge before the purchase order is issued. A collision-repair specialist should confirm left or right installation position from a corner-profile view, then cross-check clearance beside bumper and grille before the installation begins.

Component Matching Record

Complete any functional test appropriate to the component before closing trim or returning the vehicle. Recorded packing is 79 × 50 × 51CM / 10PCS; reconfirm current packing when freight is quoted.

Purchase Preparation

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

What is the listed vehicle application?

Application information points to Hyundai I10 ’07 / I10 ’11. A workshop should still compare the removed item and mounting location before ordering.

What should be compared with the removed component?

Fitment evidence should show clearance beside bumper and grille, electrical plug and pin layout and the position where the component will be installed.

How can a trade buyer request pricing?

Include packaging questions, requested quantity and the receiving country in the initial enquiry. This information helps separate technical confirmation from the later shipping calculation.