82405-D3100 / 82406-D3100 Rear Bumper Lamp for Hyundai Tucson ’16

Rear Bumper Lamp for Hyundai Tucson ’16: The following information supports a structured pre-order check for trade buyers. The component belongs to the lighting inspection group.

Product Specifications

Buyer Verification Notes

This rear bumper lamp is associated with Hyundai Tucson ’16. The references 82405-D3100 / 82406-D3100 support identification but do not replace a physical comparison. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Physical Fitment Points

• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position
• Clearance beside bumper and grille
• Lens profile and outer edge

A body-shop buyer should cross-check electrical plug and pin layout, document mounting tabs around the housing, and measure lens profile and outer edge before the packing plan is prepared. This route applies to the rear bumper lamp shown for Hyundai Tucson ’16.

If images accompany the enquiry, include a chassis-plate image, a side-profile photograph, and a straight-on view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A body-shop buyer can begin with chassis-plate image to cross-check electrical plug and pin layout. A second image should show left or right installation position from side-profile photograph. Before the packing plan is prepared, document lens profile and outer edge and note any difference from the removed component. Keep these observations with the Hyundai Tucson ’16 vehicle record.

The installation team should compare lens profile and outer edge from a corner-profile view, then measure lens profile and outer edge before the replacement is test-positioned. The receiving technician should evaluate clearance beside bumper and grille from a straight-on view, then verify left or right installation position before the installation begins. The stock controller should assess lens profile and outer edge from an adjacent-panel image, then assess electrical plug and pin layout before the installation begins. The installation team should mark mounting tabs around the housing from an upper-edge image, then measure lens profile and outer edge before the stock request is released.

Commercial Request Details

Trial-position the component with nearby trim loosened only as required by workshop procedure. No packing entry is published here; request current carton and quantity information with the quotation.

Reference Check

Quotation review is faster when quantity, shipping destination and original-part images arrive together. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

What vehicle information should be checked first?

This rear bumper lamp appears under Hyundai Tucson ’16. Review the exact vehicle version rather than relying on the model name by itself.

What should a workshop inspect before purchase?

Use the old component to check electrical plug and pin layout and left or right installation position. Also state the installation side or position in the enquiry.

What information is needed for a quotation?

Quotation review is faster when quantity, shipping destination and original-part images arrive together. Keep each requested product on a separate line when several parts share one shipment.