86511-4H000 Front Bumper (W / O Hole) for Hyundai Starex ’08

Front Bumper (W / O Hole) for Hyundai Starex ’08: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Purchase Preparation

This front bumper (w / o hole) is associated with Hyundai Starex ’08. Compare 86511-4H000 character by character with the marking on the removed component. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Installation Planning

• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature

The receiving technician should assess bracket and bolt-hole spacing, confirm lamp or grille openings, and capture overall corner curvature before the shipment is booked. This route applies to the front bumper (w / o hole) shown for Hyundai Starex ’08.

If images accompany the enquiry, include a removed-part overview, a straight-on view, and a vehicle-side photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The receiving technician can begin with removed-part overview to assess bracket and bolt-hole spacing. A second image should show side-retainer engagement from straight-on view. Before the shipment is booked, confirm overall corner curvature and note any difference from the removed component. Keep these observations with the Hyundai Starex ’08 vehicle record.

The procurement contact should evaluate bracket and bolt-hole spacing from a chassis-plate image, then verify bracket and bolt-hole spacing before the delivery plan is confirmed. The procurement contact should measure bracket and bolt-hole spacing from an upper-edge image, then mark upper edge alignment below the lamps before the commercial request is submitted. The maintenance supervisor should compare upper edge alignment below the lamps from a fastener detail, then evaluate overall corner curvature before the shipment is booked. The maintenance supervisor should trace overall corner curvature from an original-label photograph, then measure upper edge alignment below the lamps before the commercial request is submitted.

Component Matching Record

Trial-position the component with nearby trim loosened only as required by workshop procedure. Recorded packing is 170 × 16 × 32CM / 1PCS; reconfirm current packing when freight is quoted.

Reference Check

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

What is the listed vehicle application?

This page associates the front bumper (w / o hole) with Hyundai Starex ’08. The vehicle record and original component should agree with the pictured version.

Which details help confirm the correct version?

Ask the workshop to inspect bracket and bolt-hole spacing together with side-retainer engagement. VIN or chassis information can clarify market-specific differences.

What information is needed for a quotation?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Packing and freight can be discussed after the component version has been identified.