86611-4A500 Rear Bumper for Hyundai Starex ’05 / Starex ’08

Rear Bumper for Hyundai Starex ’05 / Starex ’08: Use the model label as a starting point, then verify the actual mounting layout on the vehicle. The component belongs to the bumper inspection group.

Product Specifications

Component Matching Record

This rear bumper is associated with Hyundai Starex ’05 / Starex ’08. The numbers 86611-4A500 are most useful when supported by VIN or chassis data and clear photographs. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Application Review

• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps
• Overall corner curvature
• Bracket and bolt-hole spacing

The receiving technician should compare lamp or grille openings, photograph side-retainer engagement, and align bracket and bolt-hole spacing before the quotation is approved. This route applies to the rear bumper shown for Hyundai Starex ’05 / Starex ’08.

If images accompany the enquiry, include a fixing-point close-up, a fastener detail, and an original-label photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The receiving technician can begin with fixing-point close-up to compare lamp or grille openings. A second image should show upper edge alignment below the lamps from fastener detail. Before the quotation is approved, photograph bracket and bolt-hole spacing and note any difference from the removed component. Keep these observations with the Hyundai Starex ’05 / Starex ’08 vehicle record.

The maintenance supervisor should photograph overall corner curvature from an original-label photograph, then capture lamp or grille openings before the packing plan is prepared. The stock controller should record bracket and bolt-hole spacing from a corner-profile view, then confirm upper edge alignment below the lamps before the carton is allocated. A collision-repair specialist should record side-retainer engagement from a vehicle-side photograph, then document overall corner curvature before the installation begins. The stock controller should inspect overall corner curvature from an underside image, then trace overall corner curvature before the stock request is released.

Commercial Request Details

Measure questionable mounting distances before modifying any surrounding component. No packing entry is published here; request current carton and quantity information with the quotation.

Installation Planning

A complete sourcing request names the quantity, delivery market and the comparison information used. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Frequently Asked Questions

What model is associated with this replacement part?

The recorded application is Hyundai Starex ’05 / Starex ’08. Confirm trim, market specification and the removed rear bumper before purchase.

What evidence is useful for a fitment review?

Check lamp or grille openings, confirm upper edge alignment below the lamps, and retain the removed part until the replacement has been compared side by side.

What should a distributor send for a quotation?

A complete sourcing request names the quantity, delivery market and the comparison information used. Include clear original-part photographs when the exact configuration needs further review.