86510-4A500 Front Bumper for Hyundai Starles / Starex

Front Bumper for Hyundai Starles / Starex: Review the identification points below before adding this component to a repair estimate. The component belongs to the bumper inspection group.

Product Specifications

Identification Summary

This front bumper is associated with Hyundai Starles / Starex. Compare 86510-4A500 character by character with the marking on the removed component. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Component Matching Record

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

The repair planner should record overall corner curvature, note bracket and bolt-hole spacing, and confirm upper edge alignment below the lamps before the commercial request is submitted. This route applies to the front bumper shown for Hyundai Starles / Starex.

If images accompany the enquiry, include an underside image, a straight-on view, and an upper-edge image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The repair planner can begin with underside image to record overall corner curvature. A second image should show lamp or grille openings from straight-on view. Before the commercial request is submitted, note upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai Starles / Starex vehicle record.

The stock controller should compare overall corner curvature from a full component outline, then verify lamp or grille openings before the delivery plan is confirmed. The stock controller should confirm overall corner curvature from a side-profile photograph, then trace bracket and bolt-hole spacing before the stock request is released. The procurement contact should verify bracket and bolt-hole spacing from an original-label photograph, then align bracket and bolt-hole spacing before the commercial request is submitted. The maintenance supervisor should confirm overall corner curvature from an installation-opening picture, then capture upper edge alignment below the lamps before the quotation is approved.

Pre-Order Inspection

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 180 × 60 × 55CM / 5PCS; reconfirm current packing when freight is quoted.

Fitment Evidence

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Buyer Questions

Which vehicle is this component listed for?

The listing covers Hyundai Starles / Starex. Because configurations may vary, check the actual installation area before approving the front bumper.

How is the pictured version best verified?

Fitment evidence should show overall corner curvature, lamp or grille openings and the position where the component will be installed.

How should a wholesale request be submitted?

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Include clear original-part photographs when the exact configuration needs further review.