86611-43800 Back Bumper for Hyundai H100panel Van’93-’95 / H100panel Van’96

Back Bumper for Hyundai H100panel Van’93-’95 / H100panel Van’96: The following information supports a structured pre-order check for trade buyers. The component belongs to the bumper inspection group.

Product Specifications

Identification Summary

This back bumper is associated with Hyundai H100panel Van’93-’95 / H100panel Van’96. Cross-check 86611-43800 against the removed item, paying attention to every prefix, suffix and character. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Physical Fitment Points

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

A body-shop buyer should confirm overall corner curvature, mark bracket and bolt-hole spacing, and evaluate upper edge alignment below the lamps before the installation begins. This route applies to the back bumper shown for Hyundai H100panel Van’93-’95 / H100panel Van’96.

If images accompany the enquiry, include an original-label photograph, a lower-retainer view, and a chassis-plate image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A body-shop buyer can begin with original-label photograph to confirm overall corner curvature. A second image should show lamp or grille openings from lower-retainer view. Before the installation begins, mark upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai H100panel Van’93-’95 / H100panel Van’96 vehicle record.

The service adviser should review lamp or grille openings from a fixing-point close-up, then evaluate overall corner curvature before the commercial request is submitted. The stock controller should assess bracket and bolt-hole spacing from an original-label photograph, then review overall corner curvature before the carton is allocated. The parts coordinator should document overall corner curvature from a rear mounting view, then photograph bracket and bolt-hole spacing before the purchase order is issued. A body-shop buyer should cross-check side-retainer engagement from an underside image, then photograph upper edge alignment below the lamps before the purchase order is issued.

Buyer Verification Notes

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 160 × 32 × 23CM / 5PCS; reconfirm current packing when freight is quoted.

Installation Planning

Distributors may request pricing by stating volume, destination and the vehicle identification data held. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

What model is associated with this replacement part?

The listing covers Hyundai H100panel Van’93-’95 / H100panel Van’96. Because configurations may vary, check the actual installation area before approving the back bumper.

What should be compared with the removed component?

Fitment evidence should show overall corner curvature, lamp or grille openings and the position where the component will be installed.

What should a distributor send for a quotation?

Distributors may request pricing by stating volume, destination and the vehicle identification data held. The supplier can then review the product version, carton requirements and delivery options.