92401-S1500 / 92402-S1500 Outer Tail Light Assembly for Hyundai Santa Fe ’21

Outer Tail Light Assembly for Hyundai Santa Fe ’21: This page brings the main vehicle, component and comparison details into one sourcing reference. The component belongs to the lighting inspection group.

Product Specifications

Physical Fitment Points

This outer tail light assembly is associated with Hyundai Santa Fe ’21. Compare 92401-S1500 / 92402-S1500 character by character with the marking on the removed component. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Repair Planning Notes

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The procurement contact should measure clearance beside bumper and grille, mark lens profile and outer edge, and cross-check left or right installation position before the replacement is test-positioned. This route applies to the outer tail light assembly shown for Hyundai Santa Fe ’21.

If images accompany the enquiry, include a full component outline, a full component outline, and a fastener detail. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The procurement contact can begin with full component outline to measure clearance beside bumper and grille. A second image should show electrical plug and pin layout from full component outline. Before the replacement is test-positioned, mark left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’21 vehicle record.

The maintenance supervisor should capture left or right installation position from an original-label photograph, then review clearance beside bumper and grille before the fitment decision is signed off. The importing distributor should document clearance beside bumper and grille from a side-profile photograph, then verify lens profile and outer edge before the quotation is approved. The service adviser should mark lens profile and outer edge from a fastener detail, then cross-check clearance beside bumper and grille before the vehicle is dismantled. The procurement contact should photograph clearance beside bumper and grille from a fastener detail, then evaluate electrical plug and pin layout before the packing plan is prepared.

Pre-Order Inspection

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. No packing entry is published here; request current carton and quantity information with the quotation.

Replacement Selection Guide

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

What model is associated with this replacement part?

The associated model designation is Hyundai Santa Fe ’21. Confirm the body or electrical configuration relevant to this outer tail light assembly.

How should fitment be checked before ordering?

Review clearance beside bumper and grille first, then inspect electrical plug and pin layout on the vehicle. Clear photographs help the supplier assess the required version.

Which details help prepare shipping terms?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. This information helps separate technical confirmation from the later shipping calculation.