92401-S1000 / 92402-S1000 Outer Tail Light Assembly for Hyundai Santa Fe ’19

Outer Tail Light Assembly for Hyundai Santa Fe ’19: Review the identification points below before adding this component to a repair estimate. The component belongs to the lighting inspection group.

Product Specifications

Reference Check

This outer tail light assembly is associated with Hyundai Santa Fe ’19. Compare 92401-S1000 / 92402-S1000 character by character with the marking on the removed component. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Repair Planning Notes

• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position
• Clearance beside bumper and grille

The service adviser should document lens profile and outer edge, cross-check electrical plug and pin layout, and trace clearance beside bumper and grille before the commercial request is submitted. This route applies to the outer tail light assembly shown for Hyundai Santa Fe ’19.

If images accompany the enquiry, include an original-label photograph, an installation-opening picture, and a chassis-plate image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The service adviser can begin with original-label photograph to document lens profile and outer edge. A second image should show mounting tabs around the housing from installation-opening picture. Before the commercial request is submitted, cross-check clearance beside bumper and grille and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’19 vehicle record.

A workshop estimator should cross-check left or right installation position from an original-label photograph, then review clearance beside bumper and grille before the packing plan is prepared. The service adviser should compare lens profile and outer edge from an installation-opening picture, then assess electrical plug and pin layout before the quotation is approved. The parts coordinator should document mounting tabs around the housing from a connector close-up, then verify mounting tabs around the housing before the fitment decision is signed off. The installation team should align left or right installation position from a vehicle-side photograph, then record mounting tabs around the housing before the delivery plan is confirmed.

Component Matching Record

Protect painted and finished surfaces during handling, and verify panel gaps before tightening fasteners. Recorded packing is 92 × 46 × 39CM / 10PCS; reconfirm current packing when freight is quoted.

Vehicle Confirmation

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

What vehicle information should be checked first?

Application information points to Hyundai Santa Fe ’19. A workshop should still compare the removed item and mounting location before ordering.

What should be compared with the removed component?

Photograph lens profile and outer edge and the mounting area around mounting tabs around the housing. Combine those images with vehicle identification data for review.

What should be included in a B2B enquiry?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Keep each requested product on a separate line when several parts share one shipment.