92201-A1000 / 92202-A1000 Fog Light Led for Hyundai Santa Fe ’13

Fog Light Led for Hyundai Santa Fe ’13: A reliable quotation starts with a clear component description and physical comparison evidence. The component belongs to the lighting inspection group.

Product Specifications

Buyer Verification Notes

This fog light led is associated with Hyundai Santa Fe ’13. The numbers 92201-A1000 / 92202-A1000 are most useful when supported by VIN or chassis data and clear photographs. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Part Recognition Guide

• Left or right installation position
• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing

The stock controller should photograph left or right installation position, document clearance beside bumper and grille, and align mounting tabs around the housing before the purchase order is issued. This route applies to the fog light led shown for Hyundai Santa Fe ’13.

If images accompany the enquiry, include a vehicle-side photograph, a fixing-point close-up, and a corner-profile view. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The stock controller can begin with vehicle-side photograph to photograph left or right installation position. A second image should show lens profile and outer edge from fixing-point close-up. Before the purchase order is issued, document mounting tabs around the housing and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’13 vehicle record.

A body-shop buyer should document electrical plug and pin layout from an installation-opening picture, then measure electrical plug and pin layout before the replacement is test-positioned. The maintenance supervisor should record electrical plug and pin layout from a fastener detail, then assess clearance beside bumper and grille before the fitment decision is signed off. The procurement contact should compare electrical plug and pin layout from a fastener detail, then confirm clearance beside bumper and grille before the stock request is released. A body-shop buyer should review lens profile and outer edge from a full component outline, then measure left or right installation position before the replacement is test-positioned.

Technical Comparison Notes

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. No packing entry is published here; request current carton and quantity information with the quotation.

Replacement Selection Guide

Send the order volume and destination together with VIN or chassis information where available. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Ordering FAQ

What vehicle information should be checked first?

This fog light led is listed for Hyundai Santa Fe ’13. Use that designation as a starting point and verify the vehicle configuration before ordering.

What evidence is useful for a fitment review?

Check left or right installation position, confirm lens profile and outer edge, and retain the removed part until the replacement has been compared side by side.

What should a distributor send for a quotation?

Send the order volume and destination together with VIN or chassis information where available. Packing and freight can be discussed after the component version has been identified.