86560-2WAA0 Front Bumper Grille for Hyundai Santa Fe ’13

Front Bumper Grille for Hyundai Santa Fe ’13: Parts selection should begin with the removed component and the exact vehicle record. The component belongs to the bumper inspection group.

Product Specifications

Component Matching Record

This front bumper grille is associated with Hyundai Santa Fe ’13. Write 86560-2WAA0 on the inspection sheet and ask the workshop to confirm the same characters on the removed piece. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Purchase Preparation

• Overall corner curvature
• Bracket and bolt-hole spacing
• Lamp or grille openings
• Side-retainer engagement
• Upper edge alignment below the lamps

A vehicle inspector should confirm overall corner curvature, inspect bracket and bolt-hole spacing, and assess upper edge alignment below the lamps before the fitment decision is signed off. This route applies to the front bumper grille shown for Hyundai Santa Fe ’13.

If images accompany the enquiry, include a lower-retainer view, a connector close-up, and a chassis-plate image. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A vehicle inspector can begin with lower-retainer view to confirm overall corner curvature. A second image should show lamp or grille openings from connector close-up. Before the fitment decision is signed off, inspect upper edge alignment below the lamps and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’13 vehicle record.

The procurement contact should trace bracket and bolt-hole spacing from a rear mounting view, then mark upper edge alignment below the lamps before the stock request is released. A collision-repair specialist should record overall corner curvature from an upper-edge image, then assess upper edge alignment below the lamps before the delivery plan is confirmed. The stock controller should mark side-retainer engagement from an installation-opening picture, then capture bracket and bolt-hole spacing before the installation begins. The procurement contact should verify overall corner curvature from a corner-profile view, then align lamp or grille openings before the stock request is released.

Procurement Checklist

Inspect clips and retainers because worn hardware can affect alignment even when the main part is correct. No packing entry is published here; request current carton and quantity information with the quotation.

Repair Planning Notes

Include packaging questions, requested quantity and the receiving country in the initial enquiry. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Frequently Asked Questions

What vehicle information should be checked first?

Application information points to Hyundai Santa Fe ’13. A workshop should still compare the removed item and mounting location before ordering.

How is the pictured version best verified?

Check overall corner curvature, confirm lamp or grille openings, and retain the removed part until the replacement has been compared side by side.

How can a trade buyer request pricing?

Include packaging questions, requested quantity and the receiving country in the initial enquiry. This information helps separate technical confirmation from the later shipping calculation.