92401-2B000 / 92402-2B000 Tail Light Assembly for Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08

Tail Light Assembly for Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08: The following information supports a structured pre-order check for trade buyers. The component belongs to the lighting inspection group.

Product Specifications

Identification Summary

This tail light assembly is associated with Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08. If 92401-2B000 / 92402-2B000 appears on the original label or casting, continue by confirming holes, clips and clearance. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Fitment Evidence

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The stock controller should inspect clearance beside bumper and grille, verify lens profile and outer edge, and inspect left or right installation position before the repair schedule is finalized. This route applies to the tail light assembly shown for Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08.

If images accompany the enquiry, include an original-label photograph, a removed-part overview, and a fastener detail. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The stock controller can begin with original-label photograph to inspect clearance beside bumper and grille. A second image should show electrical plug and pin layout from removed-part overview. Before the repair schedule is finalized, verify left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08 vehicle record.

The procurement contact should cross-check electrical plug and pin layout from an installation-opening picture, then mark clearance beside bumper and grille before the quotation is approved. A collision-repair specialist should document electrical plug and pin layout from an installation-opening picture, then mark left or right installation position before the replacement is test-positioned. The maintenance supervisor should inspect lens profile and outer edge from an underside image, then align left or right installation position before the shipment is booked. The importing distributor should record lens profile and outer edge from an adjacent-panel image, then measure clearance beside bumper and grille before the quotation is approved.

Pre-Order Inspection

Retain the removed part until the replacement has been visually compared and test-positioned. Recorded packing is 89 × 43 × 49CM / 8PCS; reconfirm current packing when freight is quoted.

Vehicle Confirmation

For a trade enquiry, include required units, delivery location and photographs of the original component. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Product Questions and Answers

What model is associated with this replacement part?

Application information points to Hyundai Santa Fe ’00-’06 / Santa Fe’07-’08. A workshop should still compare the removed item and mounting location before ordering.

What should a workshop inspect before purchase?

Fitment evidence should show clearance beside bumper and grille, electrical plug and pin layout and the position where the component will be installed.

What information helps confirm availability?

For a trade enquiry, include required units, delivery location and photographs of the original component. Packing and freight can be discussed after the component version has been identified.