92403-L1000 / 92404-L1000 Inner Tail Light Assembly Led for Hyundai Sonata ’17 / Sonata ’21

Inner Tail Light Assembly Led for Hyundai Sonata ’17 / Sonata ’21: Use the model label as a starting point, then verify the actual mounting layout on the vehicle. The component belongs to the lighting inspection group.

Product Specifications

Pre-Order Inspection

This inner tail light assembly led is associated with Hyundai Sonata ’17 / Sonata ’21. The numbers 92403-L1000 / 92404-L1000 are most useful when supported by VIN or chassis data and clear photographs. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Installation Planning

• Clearance beside bumper and grille
• Lens profile and outer edge
• Electrical plug and pin layout
• Mounting tabs around the housing
• Left or right installation position

The repair planner should capture clearance beside bumper and grille, evaluate lens profile and outer edge, and record left or right installation position before the delivery plan is confirmed. This route applies to the inner tail light assembly led shown for Hyundai Sonata ’17 / Sonata ’21.

If images accompany the enquiry, include an installation-opening picture, a full component outline, and an original-label photograph. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

The repair planner can begin with installation-opening picture to capture clearance beside bumper and grille. A second image should show electrical plug and pin layout from full component outline. Before the delivery plan is confirmed, evaluate left or right installation position and note any difference from the removed component. Keep these observations with the Hyundai Sonata ’17 / Sonata ’21 vehicle record.

A vehicle inspector should inspect electrical plug and pin layout from an installation-opening picture, then capture left or right installation position before the packing plan is prepared. The receiving technician should review clearance beside bumper and grille from an adjacent-panel image, then trace lens profile and outer edge before the purchase order is issued. The installation team should verify clearance beside bumper and grille from an adjacent-panel image, then review left or right installation position before the shipment is booked. The service adviser should measure electrical plug and pin layout from a connector close-up, then photograph clearance beside bumper and grille before the purchase order is issued.

Workshop Comparison

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 83 × 32 × 47CM / 40PCS; reconfirm current packing when freight is quoted.

Technical Comparison Notes

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Fitment FAQ

Which vehicle record belongs with this product?

The listing covers Hyundai Sonata ’17 / Sonata ’21. Because configurations may vary, check the actual installation area before approving the inner tail light assembly led.

How can an incorrect order be avoided?

Check clearance beside bumper and grille, confirm electrical plug and pin layout, and retain the removed part until the replacement has been compared side by side.

What information is needed for a quotation?

Provide quantity, destination country and the clearest available vehicle details for a B2B quotation. Providing the vehicle record at the start reduces follow-up questions during quotation.