87711-2D510 Moulding(W / 0 Bright) for Hyundai Elantra ’04

Moulding(W / 0 Bright) for Hyundai Elantra ’04: Review the identification points below before adding this component to a repair estimate. The component belongs to the trim inspection group.

Product Specifications

Vehicle-Side Evidence

This moulding(w / 0 bright) is associated with Hyundai Elantra ’04. Write 87711-2D510 on the inspection sheet and ask the workshop to confirm the same characters on the removed piece. Use the vehicle record and the removed component together; market specification or previous repairs may change the required version.

Technical Comparison Notes

• Clip or fastener arrangement
• Door or bumper position
• Visible contour and finish
• Mounting-hole spacing
• Base footprint

A collision-repair specialist should verify clip or fastener arrangement, assess door or bumper position, and document base footprint before the quotation is approved. This route applies to the moulding(w / 0 bright) shown for Hyundai Elantra ’04.

If images accompany the enquiry, include a fastener detail, an adjacent-panel image, and an installation-opening picture. Label the evidence with the product reference shown in the specification table so the workshop and purchasing team review one configuration.

A collision-repair specialist can begin with fastener detail to verify clip or fastener arrangement. A second image should show visible contour and finish from adjacent-panel image. Before the quotation is approved, assess base footprint and note any difference from the removed component. Keep these observations with the Hyundai Elantra ’04 vehicle record.

The procurement contact should confirm mounting-hole spacing from a chassis-plate image, then capture door or bumper position before the delivery plan is confirmed. The stock controller should measure door or bumper position from a rear mounting view, then measure base footprint before the shipment is booked. The parts coordinator should cross-check base footprint from a straight-on view, then photograph visible contour and finish before the purchase order is issued. A vehicle inspector should review base footprint from a fixing-point close-up, then align base footprint before the shipment is booked.

Configuration Check

Tighten hardware in a controlled sequence after the component sits naturally in its intended location. Recorded packing is 114 × 44 × 38CM / 40SET; reconfirm current packing when freight is quoted.

Buyer Verification Notes

Repair shops should attach vehicle and removed-part evidence when asking for availability and freight. Ask the supplier to review availability, packing and delivery terms against the identified component rather than a generic model description.

Common Workshop Questions

What is the listed vehicle application?

Application information points to Hyundai Elantra ’04. A workshop should still compare the removed item and mounting location before ordering.

Which details help confirm the correct version?

Ask the workshop to inspect clip or fastener arrangement together with visible contour and finish. VIN or chassis information can clarify market-specific differences.

Which details help prepare shipping terms?

Repair shops should attach vehicle and removed-part evidence when asking for availability and freight. This information helps separate technical confirmation from the later shipping calculation.